Jackhammer
Floor Stripper

Sku – 

Cases Per Pallet – Quarts – 12/1 x 40 | Gal.- 4/1 x 48

Country of Manufacture – United States

1. Make the floor bare and free of dust. Move all furniture, rugs, and loose objects to another room. Sweep or vacuum the floor thoroughly to remove all dust.
2. Open all windows and doors. Floor finish stripper creates toxic fumes when applied, and should never be used in an area with poor ventilation. If you are not working in a space with good air flow, set up fans in front of window or doors, and/or wear a respirator mask.
   • Take care not to point fans directly at the floor, as this could dry out the floor finish stripper and interfere with the stripping process
3. Learn additional safety procedures. Rubber gloves are mandatory, and goggles are highly recommended, as floor finish strippers contain harmful chemicals that can be absorbed through the skin and damage the eyes. Long sleeves and long pants should also be worn to cover as much skin as possible. Know where the nearest running water faucet is and be ready to flush out your eyes or rinse your skin for fifteen minutes in running water if you come into contact with the floor finish stripper
4. Mix floor finish stripper and water in one bucket according to the label. Pour floor finish stripper and water into a bucket according to the instructions. 
5. Fill a second bucket with clean water. This will be used to rinse off the floor stripping solution after it has removed the finish from the floor.
6. Mop floor finish stripper over the floor. Apply enough stripper to coat the area thoroughly, but not so much that it floods the area and soaks between seams or cracks. Apply stripper more liberally in areas with a lot of wax buildup.
7. Scrub tough areas by hand or with an electric floor scrubber. Allow the stripper to soak according to instructions on the label, then use the scrub pads (with the floor scrubber if one is available) to scrape away the wax buildup.
   • Note: always wear rubber gloves.
8. Remove the floor finish stripper. Use a squeegee, floor scrubber squeegee attachment, or wet-dry vacuum to remove the wax residue and stripper. Soak up excess liquid with rags or the mop.
9. Mop the floor with clean water and let dry. Mop the floor to make sure all traces of the stripper are gone and no longer acting on your floor.

Quarts               

1 Gallon Bottles

5 Gallon Bucket

15-55 Gallon Barrel